FTO AUSTRALIA

I had to buy a new Oxy sensor because the idoits in japan cut it off when they did the half cut!

Juat go to any good auto electrical store, ask for a universal 4 wire oxygen sensor. cost around aus $100. they work just fine, been using mine for ages and no probs!

Can anyone tell me where the plug is? I've found the sensor but the wires dissappear into the car and then I lose them. Is there an easy way to get at the electrical connector inside the car to disconnect it or do I have to pull apart the carpet and the dash to find it??

You should still be able to get the connector out underneath the car, the wire goes into a rubber boot, if you pull that out of the way you will see a white plastic clip that holds the boot to the car, take that off and you should be able to get to the connector.

What he said ^

Ahhh, thats it. I thought that was just a clip to hold the rubber plud to the car. Thanks Guys!!

My god it was a b*stard soldering while you're upside down and trying the hold the wires in that crimping thing.

I think the fuel economy has slightly improved but still overall crap compared to what it used to be.

Is the sensor after the CAT the same? We got a part number for that one?

Nacho wrote: Is the sensor after the CAT the same? We got a part number for that one?

Workin' on that one - should have it by tomorrow

That sensor after the CAT, I'm not sure what it is can someone tell me, I thought it was a secondary O2 sensor but I read some where else that it was a CAT temp sensor and you could remove and put a resistor in its place so the light on the dash won't light up.

waiting desparately to see the DIY

This is where I read about the sensor after the CAT (meow )

http://www.ftooc.org/phpbb/viewtopic.php?t=38738

I'll write you a quick DIY

Step 1: Buy new FTO
Step 2: If happens again see step 1



Wait did you want the DIY for what to do when you accidentally leave the handbrake down when parked near a cliff on the beach?

Just incase anyone elses reads this the secondary sensor mention above was for the cat temp.

Nacho wrote:My god it was a b*stard soldering while you're upside down and trying the hold the wires in that crimping thing.

Why didn't you unplug the connector and go and do it on the bench

Bennoz how much did mitsu charge to hook your car up to the matrix?

50 bucks

Which wire goes to what

Top 4 wires from new O2 sensor: 2 white, 1 black, 1 grey

Bottom 4 from old one: 2 black, 1 white, 1 blue

Bennoz wrote:

Thats awesome ben just the way i had it hooked up.

Ps where you been hiding that diagram

i just had to be for my car and i got it from repco for 50 bucks thanks to mates rates haha so putting it in on fri

Great post Bennoz, was just looking for one of these. All the info in one place!