Page 2 of 2
Posted: Fri May 06, 2005 2:00 pm
by FTO338
No mate, thats me. Here's an old pic of my engine bay.
Posted: Fri May 06, 2005 2:47 pm
by Camo
G_A_V it wasnt, but i cut it down, so in the end it was the same size at both ends.
WildRide, cheers mate =)
It also cost me an extra $85 on my insurance, and i just ordered the K&N mini pod for the breather which all up, including pipe etc cost me ~$60
Any other special ideas for a CAI would be appreciated too =)
Posted: Fri May 06, 2005 4:02 pm
by G_A_V
thanks, what did you do about the crank breather ?
Posted: Fri May 06, 2005 4:09 pm
by Camo
Camo wrote:and i just ordered the K&N mini pod for the breather which all up, including pipe etc cost me ~$60
i'm getting it on tuesday =)
Posted: Sat May 07, 2005 11:25 am
by Bennoz
Apologies for the craptacular quality of the photos...
The GR version...
Posted: Sat May 07, 2005 11:53 am
by Camo
did you make the box yourself or pay someone to make it?
whats it made from?
Posted: Sat May 07, 2005 12:01 pm
by G_A_V
it looks like the uas one, i wanted to do the same thing, but i hate that pipe that they used, it broke after a couple months, plus it doesnt look like it flows too well.
I was thinking of pulling the mas apart and sticking a whole in a huge intake (like the uas one) and poking the sensor through and sealing it up with silicon. does anyone know if this would work ?
Posted: Sat May 07, 2005 2:55 pm
by Bennoz
Funnily enough the pipe itself is not too bad. Its a pretty hardy peice & I had a noticeable gain from it compared to the stock pipe. Its the air box that aint real good. I had a bastard of a time fitting it becuase I had a custom bracket holding the pod filter on previously & I had to bend & bugger around to get it all to fit in. I did try too see if i could jam the sensor in as well - and sorta redo all the box mounting spots, but sensor & filter was all just too long.
Dunno if I'd bother with silicon - It doesnt have to be that air tight