FTO AUSTRALIA

That's a rear, thought you needed fronts?

Wheel bearings are a little more important than just tyre scrubbing... if they're shagged they need to be replaced asap. A wheel bearing failure can be very dangerous.

Stick with original Koyo bearings, don't go China sh*t on important safety parts...

Nope fronts were replaced 5000km ago. I need the rears.

Any link for the Koyo ones for the rears?

Hmm, think the rears are only available as a complete hub assembly...

Try camskill or get onto Ben

Yeah, I was gonna get a set of those Ebay units, was gonna ask him first what brand the bearings are thou..

Ill send him an email and see how it goes.

Camskill is too expensive...

EDIT: after some snooping I found the company that makes these (JT bearings). This company might be different to "J&T" as stated on the ebay page. But google returned only one company in China by that name variation.

heres the link

http://www.jtbearing.net/english/Product.asp#

EDIT again: I have also emailed JT bearings to further suss these out

I would not be putting chinese bearings in my car FULL STOP.

We have done trials here at the factory with the chinese bearings and none have lasted any longer than a few months. We will never use them again.

pete_gpx wrote:

Bennoz wrote:

J wrote:

Bennoz wrote:$166.87 per side

Stay tuned for a DIY

mitsu where? i paid 210 for a rear!

Rears are different. They are integrated into the hub & you can't just replace the bearing, you need to replace the whole hub.

Ah, come to think of it, it may have been a rear...

Yep, was a facelift rear from Camskill. Different from 97 on apparently.