FTO AUSTRALIA

Edited to keep on topic...

Check General for other posts..

Thanks mr moderator


I Suck Cock

xSlurpee wrote:Thanks mr moderator


I Suck Cock

Keep it on topic please mate....

and gross

LMAO sam you homo ....

Nice wide body kit ... is there a price on that kit? estimate price is good enough

SAM..........
why you have to do this to me......

anyways..........i might buy this kit if someone can make exactly the same
but it depends on price for sure

all I will say is it will cost a sh*t load of $$$$$ to get it made up.
but it would look cool.

haha i'm currently working on making a once off of this kit too
I bet once one of us ends up getting it right everyone will start doing it then goes away the ünique factor
Once completed i reckon all up it'll end up costing me 10-12 grand for the kit that includes repainting the fto white.

@ Taeivon_Rep

I wouldnt worry about the unique factor too much, because the kit is hand made and a once off(unless someone makes a mould) it wll always be unique.

Are you planing on making a mould because I think 10-12k is way over the top. (I estimated that I could do it for around 5k)

I problem I ran into was the rear guards. The rear guard, 'C' pillar and the roof are all one panel so making a replacement panel would be out of the question. Do you have any ideas for the rear guards. Or anyboy else.

Jamie wrote:haha i'm currently working on making a once off of this kit too
I bet once one of us ends up getting it right everyone will start doing it then goes away the ünique factor
Once completed i reckon all up it'll end up costing me 10-12 grand for the kit that includes repainting the fto white.

@ Taeivon_Rep

I wouldnt worry about the unique factor too much, because the kit is hand made and a once off(unless someone makes a mould) it wll always be unique.

Are you planing on making a mould because I think 10-12k is way over the top. (I estimated that I could do it for around 5k)

I problem I ran into was the rear guards. The rear guard, 'C' pillar and the roof are all one panel so making a replacement panel would be out of the question. Do you have any ideas for the rear guards. Or anyboy else.

I was looking into that also and decided best to at least start on the front bar, im thinking of just chopping a facelift front bar and custom making the rear wing coz its huge. I reckon my budget is a tad over but was going to over budget a lot rather than fall up short. whatever is left over will go into some race rims and rubber to fit under those guards. Check back in a coupla months i should be getting there then. lol should race to see who can make the first copy of it!