Page 2 of 2
Posted: Mon Jul 21, 2008 7:42 pm
by AMACHA
Bennoz wrote:I had trouble starting mine when the air flow metre was disconnected...
when its really really cold i meen 9 degrees temperature it takes a while to turn my gpx on to i turn the key and car doesnt turn on i rev it a bit and hten it turns on but hmm...
Posted: Mon Jul 21, 2008 8:22 pm
by Bennoz
AMACHA wrote:Bennoz wrote:I had trouble starting mine when the air flow metre was disconnected...
when its really really cold i meen 9 degrees temperature it takes a while to turn my gpx on to i turn the key and car doesnt turn on i rev it a bit and hten it turns on but hmm...
Check your error codes!
Posted: Mon Jul 21, 2008 8:26 pm
by aza013
Posted: Mon Jul 21, 2008 9:39 pm
by AMACHA
i really cannot be f*kd but i will lmao maby this weekend
Posted: Mon Jul 21, 2008 9:41 pm
by I8A4RE
ok i just found this thread. First off if you had of asked me ben i could of told you were reading them wrong
.
Make sure when you check error codes that you do a reset firsrt then take the car for a spin, then check. Cause if your anything like me then you will run your car with all sorts of connections unplug.
Simple way to check the crank angle sensor is to disconnect it, then try and start it, but yes i am still getting that error and the car is running however if i disconnect it i t will not run at all
My car starts no problems at all with the AFM disconnected but drives like sh*t with it still disconnected.
Re: I done busted it - error code help
Posted: Sun Jul 27, 2008 11:38 am
by Syst3m_NZ
Bennoz wrote:Have attached an Evoscan log for those that can interpret them.
From looking at the log it appears you weren't able to get the speed reading working either?
Posted: Sun Jul 27, 2008 12:56 pm
by Bennoz
I was only idling in the garage
