Page 2 of 2
Posted: Wed Oct 24, 2007 3:08 pm
by manofwood
FtoSam wrote:Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...
would be over 160kw though
where is this engine, or who can i talk to about it? i'm looking to build an n/a monster without the bullshit of mixing 3 motors
Posted: Wed Oct 24, 2007 3:15 pm
by Delvance
manofwood wrote:FtoSam wrote:Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...
would be over 160kw though
where is this engine, or who can i talk to about it? i'm looking to build an n/a monster without the bullshit of mixing 3 motors
www.rpw.com.au 
Posted: Wed Oct 24, 2007 4:43 pm
by FtoSam
Have a chat to David... Tell him Sam sent you...
he will let you know EXACTLY what you can and cant do....
Posted: Wed Oct 24, 2007 6:58 pm
by FtoSam
Dont know about KW from the new engine... will know as soon as the GT-28-71R goes in...
And i've spent $20-$22k
Posted: Wed Oct 24, 2007 9:35 pm
by rock_it
yellowftogpx wrote:rock_it wrote:We had a group Dyno day at Menai a little while back ... Pulse racing I think it was ...
As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...
I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...
As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...
What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...
I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...
thanks a lot ,ROCK_IT !! i think MRT is the closet place but they charge $150 for 3 dyno runs...i think its too expensive ...
my fto is YELLOW GPX MANUAL 95MODEL , LIMITED EDITION..only done the exhaust and intake system..67000KMS ...excellent condition...i hope my fto can get around 105kws atw..i will post some pics later on..
I will probably go for Richol.. anyone got address?
Ricol usually charge about $77 an hour ... So it should be a lot cheaper the MRT .. Not really a fan of Brad and the boys out there ... But hey, just me ..
Ricol is in 11/12-14 Norman St Peakhurst ... Give Colin or Rick a call ... Tell em Craig with the Evo & Fto told you to speak with them ... Colin usually does the Dyno stuff though ...
Ph:95332729
Posted: Wed Oct 24, 2007 11:17 pm
by yellowftogpx
rock_it wrote:yellowftogpx wrote:rock_it wrote:We had a group Dyno day at Menai a little while back ... Pulse racing I think it was ...
As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...
I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...
As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...
What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...
I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...
thanks a lot ,ROCK_IT !! i think MRT is the closet place but they charge $150 for 3 dyno runs...i think its too expensive ...
my fto is YELLOW GPX MANUAL 95MODEL , LIMITED EDITION..only done the exhaust and intake system..67000KMS ...excellent condition...i hope my fto can get around 105kws atw..i will post some pics later on..
I will probably go for Richol.. anyone got address?
Ricol usually charge about $77 an hour ... So it should be a lot cheaper the MRT .. Not really a fan of Brad and the boys out there ... But hey, just me ..
Ricol is in 11/12-14 Norman St Peakhurst ... Give Colin or Rick a call ... Tell em Craig with the Evo & Fto told you to speak with them ... Colin usually does the Dyno stuff though ...
Ph:95332729
cool , thanks Craig! yeh , i already sent them an email and see if i can make an appointment..
Posted: Thu Oct 25, 2007 8:07 am
by rock_it
Hmmm ... Not sure what their email communication is like ... But let me know how you go ...