Revzone - nunawading

EURO · Post by **EURO** » Fri Sep 16, 2005 7:29 pm

Anyone Had much to do with Revzone in Nunawading?

Was going to use them for a compression test on my car ($180). Any experiences from anyone?

FTO338 · Post by **FTO338** » Fri Sep 16, 2005 11:51 pm

I got my RSM installed there, they were recommended by another forum although they did a good job, the guy who installs it had put the wrong setting, and he put 4 cylinders instead of 6

FTOluv · Post by **FTOluv** » Sat Sep 17, 2005 9:18 pm

i went to Autobahn today and u can buy a pretty good compression testing gear for cheaper than $180.

Post by **Supplanter** » Sat Sep 17, 2005 10:16 pm

I took my baby there for its first service. $400 all inclusive

They used Motul oil.
A bit pricey but they know what an FTO is.

EURO · Post by **EURO** » Wed Aug 16, 2006 5:30 pm

Dropped my car off there today - lots of new faces......
has craig moved on?

khunjeng · Post by **khunjeng** » Wed Aug 16, 2006 11:52 pm

Craig is still there

He just moded my R33 and I went down to see him 1 week ago. Justin has been in Sydney and didn't emil me today maybe he is away again.

My car will be back there in a month for a few more things.

Chris.

EURO · Post by **EURO** » Thu Aug 17, 2006 4:03 pm

yep - premature call by me..... rang me today....

p.s. chris he tried to install the magnecor leads said they are the wrong size and not a snug fit.. did not suggest installing them - will pm you too.

khunjeng · Post by **khunjeng** » Fri Aug 18, 2006 12:23 am

EURO wrote:yep - premature call by me..... rang me today....

p.s. chris he tried to install the magnecor leads said they are the wrong size and not a snug fit.. did not suggest installing them - will pm you too.

thats intresting. no1 else has complained and in the end some1 wanted mine and I didn't even fit them myself.

But if they reckon there not right, they must be wrong. Maybe I should have a look but lets just send them back and tell them we want new ones.

EURO · Post by **EURO** » Fri Aug 18, 2006 6:36 pm

yeah - he said lengths were fine but the area that fits into the rocker cover was loose or something - and another connection point or something was the wrong size...

basically he was worried that condenstation could easily get into the boot sleeve area and cause rust on the plug.

khunjeng · Post by **khunjeng** » Sat Aug 19, 2006 1:52 am

EURO wrote:yeah - he said lengths were fine but the area that fits into the rocker cover was loose or something - and another connection point or something was the wrong size...

basically he was worried that condenstation could easily get into the boot sleeve area and cause rust on the plug.

the whole leads GB was a nightmare...never touching those leads again the guy who makes them has no idea...

let send them back and get some new ones.

Post by **Bennoz** » Sat Aug 19, 2006 2:03 am

I've met the guy who makes 'em........

khunjeng · Post by **khunjeng** » Sat Aug 19, 2006 3:45 pm

Bennoz wrote:I've met the guy who makes 'em........

yeah u told me...and based on the output of the work its pot luck to see if they work or not...

I didn't even what the leads but everyone seemed keen..peer pressure and all

but dave we can sort u out I'm sure...