Tacho not working after emanage install

barfy · Post by **barfy** » Mon May 08, 2006 1:06 pm

Anyone have this prob and ideas what it might be ?

bigpitty1 · Post by **bigpitty1** » Tue May 09, 2006 8:28 pm

I'm only going to have a guess but I reacon it could be the wire from the ECU to the tacho is disconnected, and also I think that the emanage has a tacho output wire, you might have to connect the tacho to that.

I'm only guessing but thats what I reacon.

Post by **Bennoz** » Tue May 09, 2006 11:21 pm

Hmmm, big pitty could be right...

The tacho wire runs from pin 51 (white) on the ECU to the Ignition Failure Sensor (pin 2 on the plug) - you could try checking contiuity on that wire.

It could be the the Ignition Failure sensor has packed up

It could be the line fron the tacho to the ECU (sorry cant remember pin outs)