Hey Guys
Was thinking of either boring out my Throttle Body to 65mm or getting a 65mm Magna one and retro fitting it to my GPX.
Can you guys tell me.
A. Is it a worthwhile Mod
B. How much it will cost to bore or get a 65mm Magna retro fitted
and
Lastly
WHERE in Melbourne I would go to get the stock one Machined or get a Magna one??
Cheers
Throttle Body
Moderators: IMC, Club Staff
-
mcgal
- Apprentice
- Posts: 27
- jedwabna poszewka promocja
- Joined: Sat Feb 11, 2006 6:00 pm
-
FTO338
- Oldtimer
- Posts: 6712
- Joined: Sun Feb 09, 2003 6:00 pm
- Location: Port Melbourne: Pimping with RX400h, B200 Turbo.
I've got a Magna one & a machined 65mm as well.
But i still haven't put them on......
Even worst i haven't pick up my 65mm yet.....so little time....so much to do....
Once i put it on, then i can tell you if its worth it.
But i still haven't put them on......
Even worst i haven't pick up my 65mm yet.....so little time....so much to do....Once i put it on, then i can tell you if its worth it.
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
-
barfy
- Mechanic
- Posts: 779
- Joined: Wed Feb 04, 2004 6:00 pm
- Location: Adelaide
Its worth doing IF you get all the other air flow mods, like bored out manifold and hi flow cat back exhaust system, oh you might as well have extractors and then you need a FPR and now that you have all that u need a ECU to tune it to get the most gains from it haha
The list goes on
and so do the $$$
The list goes on
and so do the $$$[img]http://i142.photobucket.com/albums/r103/barfy76/barfycopy1.jpg[/img]