Below is some pics of my dyno sheets after i had a cat back exhaust done and emanage installed. 108Kw at the wheels i think is pretty low but im really happy with the amount of torque gains.
The exhaust is JunBL 2.5 inch with high flow cat, got about 8Kw off that and around 10kw off the emanage.
Just wondering with having a lot of air flow mods like UAS CAI, RPW TB and manifold setup, would these mods show gains on the dyno as there is no air being forced in as the car is standing still ?
Mate as long as you happy of the way it drive & handle. Thats all it matter.
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
Yeah im not sure whats going on i mean i have RPW extractors, Manifold/TB, FPR, UAS CAI, JunBL cat back exhaust all tuned with a Greddy emange, i was thinking i would be getting around 120Kw atw with this set up...
I think we point this out almost, yes i mean almost millions of time Every dyno is different. So the only way you can compare is if everyone go to the same dyno shop & did a before & after.
Or you can take both of your car to a drag strip & see what happen
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
Every dyno is different. So the only way you can compare is if everyone go to the same dyno shop & did a before & after. 
