hi,
this would be strange for u but could anyone whos got these make a tracing of it for me. im trying to make one from a cf sheet that ive got. need it so i do a good job . please
I give you a better idea, why don't you use the "carbon" technique, & then cut it out.
Just in case you don't know what a "carbon" technique is, is what we did in primary school, put a piece of paper on top of the instrument cluster, & then run over it with either carbon dust or use coloring pencil & you get the out line sketches of the panel.
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
hobby knife? hmmm... you still would need some steady hands. i know if that was me i would had a spazz attack in my hand while cutting and end up cutting the whole thing in half. hahaha. nice job once again.