Modicoat

Post by **dstocks** » Wed Jul 13, 2005 6:56 pm

Wondering if anyone has ever tried this???

http://www.modicoat.com/

I have the stick on carbon fibre stuff you get off ebay, but this looks infinitely better (although a little more expensive)

akuma3 · Post by **akuma3** » Wed Jul 13, 2005 7:01 pm

well i have wood grain in my car ... was happy with it at start but nothing too exciting afterward, got pay out for sports car should fit carbon instead

Post by **dstocks** » Wed Jul 13, 2005 7:08 pm

The stick on suff I have is woodgrain and it looks reasonable, but the fit isnt great and there are a couple of joins that annoy the !@#@ out of me. I guess that at least I can remove it. While the Modicoat may look better (I guess) it will be permanent and there will be no going back.

FTO338 · Post by **FTO338** » Wed Jul 13, 2005 8:22 pm

There were few members look into this before, but they charge an arms & legs for it, and non of them end up going ahead with it.

shue · Post by **shue** » Thu Jul 14, 2005 10:42 am

theres a place in melb called dash board centre that does the same kinda coating stuff as well. got quoted around 300-400$ for coating the whole centre dash panel,vents etc in cf. its not a cf lamination but some kinda plastic paint thingy. check out there website as well www.dashboardcentre.com.au