Was about to take the heads off but I noticed the bolts are a bit different.
Are they torx or spline and I presume they are M10 as an M10 hex socket wouldn't go on but an M11 hex would but was loose due to the type?
They didn't have any singles or sets of either in Autopro or repco up here so going to have to order some.
Cylinder head bolts - what socket, spline?
Moderators: IMC, Club Staff
-
Rob Furniss
- Oldtimer
- Posts: 1394
- jedwabna poszewka promocja
- Joined: Wed Jan 19, 2011 11:32 pm
- Location: Perth
- Contact:
-
Vectose
- Forum Moderator
- Posts: 3952
- Joined: Sun Nov 28, 2010 8:45 pm
- Location: Newcastle
Re: Cylinder head bolts - what socket, spline?
m10 12 point socket can't use a 6 point
Bennoz wrote:A whoooole lot 'o jismTechnikhaus wrote:What is in said Bens big penis by the way?
-
Rob Furniss
- Oldtimer
- Posts: 1394
- Joined: Wed Jan 19, 2011 11:32 pm
- Location: Perth
- Contact:
Re: Cylinder head bolts - what socket, spline?
Thanks mate.Vectose wrote:m10 12 point socket can't use a 6 point
-
spetz
- Oldtimer
- Posts: 2915
- Joined: Wed Mar 03, 2004 6:00 pm
Re: Cylinder head bolts - what socket, spline?
There are some allen key bolts on the heads too right at the bottom, does anyone know what these are for?