Changing ignition ring bulb

[klyfe]

So getting into the steering column is easy, but once I'm there, I can't seem to work out how to go about replacing the ignition ring bulb.

There is a little black plug coming from the barrel, but other than that, I can't see anything!

Is the bulb in the plug?

Do I need to remove the ignition barrel?

[klyfe]

Anyone?

[phunkydude]

viewtopic.php?f=12&t=22832

Not a biggy mate. you only need to remove the lower plastic from the steering column. 4 screws - 2 at the front either side of the 'raise/lower steering wheel' lever, one in the deep hole, and one right at the back near the base of the lever.

Now, stick your head in under there and look up from the floor, in behind the silver metal of the ignition. You'll see a T5 bulb connector in up behind there tucked away almost out of reach - pretty identical to the one on your ciggy lighter. with one finger from below, and one from dash-side, you can twist it anticlockwise and pop it out. Bit fiddly, but doable. One T5 wedge LED will pop straight into the holder... and re-assemble!

[klyfe]

*~delightful!~*!
I looked to see if there had been anything on it before, I just must not have looked hard enough.
Thankyou!