Yes moar beer is my typical solution, but technically all its held by is a spring washer....
Its not the weight of the blow that free's it, its the sweet spot you hit in on....
This list right?
Moderators: IMC, Club Staff
-
Bennoz
- National President
- Posts: 23676
- jedwabna poszewka promocja
- Joined: Fri Jan 21, 2005 6:00 pm
- Location: Sydney
- Contact:
Re: This list right?
zomfg
Yes moar beer is my typical solution, but technically all its held by is a spring washer....
Its not the weight of the blow that free's it, its the sweet spot you hit in on....
Yes moar beer is my typical solution, but technically all its held by is a spring washer....
Its not the weight of the blow that free's it, its the sweet spot you hit in on....
-
payaya
- Oldtimer
- Posts: 3670
- Joined: Sat Sep 06, 2003 5:00 pm
Re: This list right?
Yep noticed when I had the outer housing off the bashing would not have worked anyway as I smashed it so hard the splines on the outer edge of the shaft were damaged which would have stopped me from getting th cv off anyway.Bennoz wrote:zomfg
Yes moar beer is my typical solution, but technically all its held by is a spring washer....
Its not the weight of the blow that free's it, its the sweet spot you hit in on....