Driveshafts / CV's in Sydney

[Shane001]

Hey guys, can anyone recommend anyone in Sydney for replacement driveshafts or rebuilds? I think mine may be on the way out. Or anyone got any lying around (95 GPX Manual)? Same as;
HNFH - GP (Mivec), 5FM/T
HNFH3 - GP Version-R (Mivec), 5FM/T
HNFH4 - GP Version-R2 (Mivec), 5FM/T
HNGH - GPX (Mivec), 5FM/T
HNHM - GR, 5FM/T
HNHM3 - GR-Limited, 5FM/T
HNHM4 - GR Sports-Package, 5FM/T
HRFH - GP (Mivec), 4FA/T
HRGH - GPX (Mivec), 4FA/T

Thanks.

Shane.

[Shane001]

Um, this isn't really a 'Wanted to buy' thread, more a 'can someone recommend someone' thread...

[Bennoz]

Yeah I got a driveshaft guy mate. I'll scratch up his number for you.

Sorry I haven't got back to your PM, yes normally I am around your area, but this week has been a sh*t fight at work.

[Shane001]

No worries, thanks Ben, there is a little movement in the uni joint and we noticed it was a little worn when we replaced the boot, but need an opinion as to how bad it is and whether it needs replacing now or if it's OK for a while (fingers crossed)...

[Bennoz]

Inner or outer joint?

[bushido]

There is this guy in Brookvale who made me a set of driveshafts from various mitsu bits for my cusco. T & A driveshafts, 27 Orchard rd, Brookvale.

His number is 99399855. Think his name was Frank.

[Bennoz]

Thats the one ^^

He made up my inner joints too.

[Shane001]

Inner or outer joint?

Well there's a little movement in them all, which I assume is normal and necessary though. The joint with the most movement is the inner drivers side (gearbox end of the shaft). But not knowing what is normal I don't know if this is OK or not...

[bushido]

Thats the one ^^

He made up my inner joints too.

Yeh Herman recommended him after what he did to yours =)