New rubber piping
Moderators: IMC, Club Staff
- eddiii
- Veteran Mechanic
- Posts: 923
- jedwabna poszewka promocja
- Joined: Sun Dec 14, 2008 6:00 pm
- Location: sydney
- aza013
- NSW Coordinator
- Posts: 9087
- Joined: Mon Mar 26, 2007 5:00 pm
- Location: The Shire
- Contact:
- aza013
- NSW Coordinator
- Posts: 9087
- Joined: Mon Mar 26, 2007 5:00 pm
- Location: The Shire
- Contact:
- bushido
- Oldtimer
- Posts: 1566
- Joined: Mon Oct 29, 2007 5:00 pm
- Location: Sydney
eddii the rim in that pic would be a wider rim than a 7.5 or 8. in order to get that much dish you would need a wide rim, say at least a 9 inch with a tough (read low) offset. That rim looks like the 19 x 9.5 with an offset of +25-28. We all know something like that wont fit with some serious guard and fender work.
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
###########Unofficially the loudest FTO in NSW???##########
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
###########Unofficially the loudest FTO in NSW???##########
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
- aza013
- NSW Coordinator
- Posts: 9087
- Joined: Mon Mar 26, 2007 5:00 pm
- Location: The Shire
- Contact:
- aza013
- NSW Coordinator
- Posts: 9087
- Joined: Mon Mar 26, 2007 5:00 pm
- Location: The Shire
- Contact:
- aza013
- NSW Coordinator
- Posts: 9087
- Joined: Mon Mar 26, 2007 5:00 pm
- Location: The Shire
- Contact:
- J
- Oldtimer
- Posts: 2182
- Joined: Fri Apr 18, 2008 5:00 pm
- Location: Sydney West
- Contact:
dish - the amount of dish depends on offset. the lower your offset the bigger dish you will have. a wider rim (eg. 8/9inch wide) will also have an effect on dish.
offset -18x8 rims with the usual +35/34/37 bob jane tmart offset can allow 3-5cm of dish from when i did some calling around a while ago, depending on spoke design.
offset should be stamped on the back of the rim. if not its on a sticker with the size and width of the rim.
---
you may have to remove the plastic guards behind the wheel arches if your car is preety low
offset -18x8 rims with the usual +35/34/37 bob jane tmart offset can allow 3-5cm of dish from when i did some calling around a while ago, depending on spoke design.
offset should be stamped on the back of the rim. if not its on a sticker with the size and width of the rim.
---
you may have to remove the plastic guards behind the wheel arches if your car is preety low
- arctan
- Grease Monkey
- Posts: 259
- Joined: Sat Feb 28, 2009 6:00 pm
- Location: Fairfield, Sydney
- Contact:
- Bennoz
- National President
- Posts: 23668
- Joined: Fri Jan 21, 2005 6:00 pm
- Location: Sydney
- Contact:
- arctan
- Grease Monkey
- Posts: 259
- Joined: Sat Feb 28, 2009 6:00 pm
- Location: Fairfield, Sydney
- Contact:
- aza013
- NSW Coordinator
- Posts: 9087
- Joined: Mon Mar 26, 2007 5:00 pm
- Location: The Shire
- Contact: