GR loom

gr_fto_reborn · Post by **gr_fto_reborn** » Wed Nov 05, 2008 6:35 am

I am in need of A GR loom but it needs to have four green plugs that go into the ECU. Any help would be appreciated. postage shouldnt be too much of a problem.

Post by **dstocks** » Wed Nov 05, 2008 7:11 am

You after the whole loom or just one of the parts. And does it need to be complete or is it going to be hacked up. MAY be able to help.[/i]

gr_fto_reborn · Post by **gr_fto_reborn** » Thu Nov 06, 2008 5:02 am

I dont need anything behind the dash but i need the whole engine loom complete. It will just make my live a bit easier while doing the 6a13 conversion.

Post by **Bennoz** » Thu Nov 06, 2008 8:49 am

Why not use the 6A13 loom? Coupled with the 6A13 ECU, you wont have too many problems. Only thing is you need to rewire a few of the engine plugs from male to female (using the GR loom heads.)

Post by **I8A4RE** » Thu Nov 06, 2008 11:41 am

Bennoz wrote:Why not use the 6A13 loom? Coupled with the 6A13 ECU, you wont have too many problems. Only thing is you need to rewire a few of the engine plugs from male to female (using the GR loom heads.)

Agreed, it much easier way of doing it. In fact im pretty sure all the conversions that i know of have done it that way

gr_fto_reborn · Post by **gr_fto_reborn** » Fri Nov 07, 2008 4:15 am

Thing is i havent a clue where to start with doing that. I would need a guide for dummies lol. i have been told that the four plug gr loom is a plug and play job.

Post by **dstocks** » Fri Nov 07, 2008 8:05 am

ill have a look on the weekend, but I think one or 2 of the wires have been cut on mine unfortunately