WTB cam shaft lobes??

Taeivon_Rep · Post by **Taeivon_Rep** » Wed Aug 06, 2008 2:50 pm

hi all,
Just got the car back from getting new valve cover gaskets put in and while they had the engine apart they noticed that the cam shaft lobes are pretty worn and will go within the next 30,000 kays.
Anyone know how much for parts to fix this problem when it eventually goes? I want to know how much to budget or maybe even buy it now to replace before it goes.

Thanks in advance

Post by **aza013** » Wed Aug 06, 2008 6:19 pm

what FTO do you have GR or GPX ?
if its a gpx I have a set sitting around that I could sell you, as for price I would have to work that out.

Taeivon_Rep · Post by **Taeivon_Rep** » Wed Aug 06, 2008 6:39 pm

aza013 wrote:what FTO do you have GR or GPX ?
if its a gpx I have a set sitting around that I could sell you, as for price I would have to work that out.

GPX

Let me know how much when u can. Is it new or used?

Post by **aza013** » Wed Aug 06, 2008 6:48 pm

used but they are only low Ks what I have been told I will get a pic up for you.

this is a link to all the parts I have I will get a close up pic of them tomorrow for you.

http://www.ftoaustralia.com/modules.php ... ic&t=13232

nvr2low · Post by **nvr2low** » Wed Aug 06, 2008 8:31 pm

hey aza do u have the rubber bits that are on the opening of the manual drive shafts don't really now what they are called but they are like rubber seals anybody now were I cn get sme as mine are old

Post by **dstocks** » Wed Aug 06, 2008 9:45 pm

I think what you are looking for are driveshaft boots. I know Bennoz recently rattled off a place where you could get these locally.

Post by **Bennoz** » Sun Aug 10, 2008 3:22 pm

Any local autoshop will do 'em. Just ask for inner or outer CV boot kits for a HJ Galant.