Basically i have taken half of it off (it is broken )...and the other half seems to be stuck...i have tried as much force as possible to take it out without breaking this piece further...so i decided maybe there is a specific way to take it off ? anyone please help ...i am attempting a repair so hopefully it works...if not...hell yea i will buy a new one...
harry90 wrote:Basically i have taken half of it off (it is broken )...and the other half seems to be stuck...i have tried as much force as possible to take it out without breaking this piece further...so i decided maybe there is a specific way to take it off ? anyone please help ...i am attempting a repair so hopefully it works...if not...hell yea i will buy a new one...
please anyone ?
good luck buying one
which bit is stuck? the top bit or the bit around the shifter?
eitherway, a flathead should do it unless your taking the clock cover off
harry90 wrote:Basically i have taken half of it off (it is broken )...and the other half seems to be stuck...i have tried as much force as possible to take it out without breaking this piece further...so i decided maybe there is a specific way to take it off ? anyone please help ...i am attempting a repair so hopefully it works...if not...hell yea i will buy a new one...
please anyone ?
good luck buying one
which bit is stuck? the top bit or the bit around the shifter?
eitherway, a flathead should do it unless your taking the clock cover off
there is a group buy
and it is the part that goes around the centre console...its meant to be one piece and goes from top left to top right around the centre console.
Open the lid of the centre console compartment and there should be a screw I think... also there is on under the cup holder, which should just pull out.
if you want to pull the centre console out (i.e the centre where the stereo is) its preety easy
you have to start from the centre glove box, take out the case and then you should be able to see your hand brake lines also, the cupholder pop the cupholder out and you should see a few screws that are holiding it in place, undo them and it should wiggle out.
Next, carefully take out the gearbox pplastic by lifting up it, it will then be stuck down by some electrical wires which you should have no problem pulling apart (just remember to know how to put it back =D)
After all thats done there should be screws holding the last piece which you undo and that should just wiggle off.
)...and the other half seems to be stuck...i have tried as much force as possible to take it out without breaking this piece further...so i decided maybe there is a specific way to take it off ? anyone please help ...i am attempting a repair so hopefully it works...if not...hell yea i will buy a new one...
