FTO AUSTRALIA

It's ugly as f**k, but not interested in pretty at the moment.

I take my hat off to you for going the hard yards to get these FTO’s back to their happy places

BUT DON’T do to good of a job as I still want the price of panda to go up

When you are tired of the rest of the car, just concentrate on the most useless part.
Not even going to run the side carpet sections. Will use the beaver panel section, re cut the boot floor section to cover the sides more even.
Just going to hard tape the sides and raptor coat it.

No rust pulling through the primer and been out in the weather for a couple of weeks.
Will give it a few more weeks before i attack the rear section.

What Haltec unit are you going for?
Are you hard wiring it in or using an adaptor?

d_dan wrote: ↑Sun Dec 11, 2022 1:28 am What Haltec unit are you going for?
Are you hard wiring it in or using an adaptor?

I make and sell custom haltech plug and play adapters.

No rust pulling through anywhere so confident i can move onto the rear section.

Sounds and looks like a little win

That's what he thinks every time he takes his pants off

Bennoz wrote: ↑Tue Dec 27, 2022 3:00 pm That's what he thinks every time he takes his pants off

Harsh but fair.

Bit of a change up in the boot.
Re routed some cables. Could have bought a smaller battery box but already had this one so did some mods for it to fit.
Lots more to do, just want it neat and functional.

You’re doing all this work on the car to make it better, then you go and put a little 400w kenwood in it !!!!

Don't get me started on these kids & their amps & subs Aza, don't get me started...

aza013 wrote: ↑Wed Jan 04, 2023 12:29 pm You’re doing all this work on the car to make it better, then you go and put a little 400w kenwood in it !!!!

Not at all interested in how loud it can go.
An amp running all speakers is far better than a head unit alone. It can do the heavy lifting.

Not a lot going on lately. Finalised the roof rust repair. Repaired seat bolsters.